The TMC REEF BIO-Gro algae reactor is designed to grow marine macro algae's such as Chaeto (Chaetomorpha) in a compact reactor saving room in your sump. Adding this is a sure way to help reduce Nitrate's and Phosphate's!
The TMC REEF BIO-Gro algae reactor is designed to grow marine macro algae's such as Chaeto (Chaetomorpha). with this reactor you can be sure to get the correct PUR rating that macro algae require without taking all the room up in your sump for a traditional Refugium. By adding this it is a sure way to help reduce Nitrate's and Phosphate's in your marine aquarium that lead to horrible Algae problems.
The method is that macroalgae will out-compete the smaller nuisance algaes, helping to keep your aquarium lovely and clean! Simply throw away the excess macroalgae when the reactor is full, leaving a small piece on each plate to start the process again. A lovely natural, self-sustaining solution to nitrate and phosphate reduction!
The algae reactor method is simple to use simply Place a small amount of macroalgae, such as Chaetomorpha, onto each algae plate, connect the pump (sold with and without pumps) 1000-2000lph and Switch the light on (for optimum results, it is recommended that the LED lighting board is set to operate on a reverse cycle and switch on when the main lights in your aquarium switch off).
1x REEF BIO-Gro per 4ft aquarium up to 500ltr
The REEF BIO-Gro has a lighting tube wth algae culture plates attached that runs down the middle of the body.
Inside the lighting tube is a double-sided LED lighting board using AquaRay technology. The 9w dimmable LED light has a unique spectrum, tailored specifically for the optimum growth of macro algae (large multicellular algaes such as Chaetomorpha sp, not the green water, single celled plankton algae). This means that the light spectrum is not just the usual red/white mix used in other models.
The REEF BIO-Gro's compact size means it can stand in a sump, hang on the inside or outside or can be run pressurised separately from the system, in any position desired.
Also included is a self-adhesive light shield which optimises the use of available light from the LED lighting board and also helps reduce light spill into your aquarium or sump. This can be cut to create a viewing strip should the user wish to monitor algae growth.
The AquaBar dimmer (code: 1780) or the AquaBar 2 channel controller (code: 3799) can be used to control the REEF BIO-Gro light.
12 month warranty.
PLEASE NOTE: Chaeto Algae is hand picked so each packet may vary in size.